Skip to main content
By using this site, I agree to the Terms and Conditions.

Search results

Filter Search Results

Form

Frontage

Standard

Use District

Density

Overlay

Special District

Results 191 - 200 of 212 for property zoning search

Search results

  • Sec. 2C.4.1. Floor Area Ratio (FAR)

    Floor area ratio or FAR is defined as the measurement of the total floor area of all buildings on a lot in relation to the size of the lot. Intent The intent of the standards of this Section (Floor Area Ratio (FAR)) is to regulate the bulk…

  • Sec. 11.3.3. Subdivision Improvements

    Requirements The streets, alleys, lots, and easements in all subdivisions subject to the provisions of this Article (Di vision of Land) shall be laid out to provide for sewer and drainage facilities. All streets and alleys and…

  • Sec. 9.2.2. Affordable Housing Incentive Program

    Intent The Affordable Housing Incentive Program aims to increase the production of affordable housing projects, including priority housing projects, by implementing state density bonus requirements as set forth in California Government Code Sec. 65915-65918 for one hundred percent…

  • Sec. 14.2.16. Yards

    General All portions of a lot between exterior walls of a building and a property line shall be designated as one of the following yard designations, and no portions of a lot shall have more than one of the…

  • Sec. 5C.3.3. Alcohol Sales Program

    Intent To enable regulations for alcohol sales to be applied through an opt-in program that serves as an alternative to traditional conditional use permit in compliance with the California Constitution. Alternative permission areas allow for the sale or dispensing of alcoholic beverages to be…

  • Sec. 2C.6.2. Height Transition

    Height transition is defined as a reduction in the maximum height of a building for a limited depth where abutting districts have substantially lower height allowances. Intent The intent of this Section (Height Transition) is to prevent looming impacts…

  • Sec. 4C.12.4. Wireless Telecommunication Facilities

    Intent The intent of the standards of this Section (Wireless Telecommunication Facilities) is to minimize visual impacts, make the installation, operation, and appearance of wireless telecommunication facilities as inconspicuous as possible, to prevent the facility from visually dominating the…

  • Sec. 5C.2.5. Heavy Commercial Uses

    Motor Vehicle Services: Light, Heavy, & Large Vehicle Supplemental Standards For new construction involving new floor area or a major remodel, bay doors and other building entrances and exits designed and intended for motor vehicle […

  • Sec. 9.2.1. State Density Bonus Program

    Intent The purpose of this Sec. 9.2.1. (State Density Bonus Program) , “State Density Bonus Program,” is to establish procedures for implementing the State Density Bonus provisions in California Government Code, Chapter 4.3. (Density Bonuses and Other Incentives), Sec. 65915-65918 , and to increase…

  • Sec. 12.3.1. Build-To Exceptions

    On a lot with an existing building where the lot is nonconforming as to the maximum build-to depth or minimum build-to width requirements, any new construction shall meet the minimum [glossary:…